MPCNC Primo Build Ep. 06 Arduino Ramps assembly and Marlin install
7.7 هزار بار بازدید -
3 سال پیش
-
The MPCNC is getting closer
The MPCNC is getting closer to completion. Getting Marlin loaded on the Arduino, and assembling the Ramps.
Video on how to change D9 pin to pin 44 5 volts
MPCNC Primo Build Ep. 12 Arduino Ramp...
Marlin Firmware page https://www.v1engineering.com/marlin-...
Credit goes to V1 Engineering for doing all the work. They sell all the parts to complete this build, you can just assemble one if you please.
https://www.v1engineering.com/
I don't go into all the details. Step by step instructions start here thanks to V1 Engineering. https://docs.v1engineering.com/mpcnc/...
Printed on a Creality Ender 3 0.4 nozzle, 60 mms, 0.28 layer height, gst3d and sunlu filament.
Files downloaded at https://www.thingiverse.com/thing:458...
Sliced with Cura 4.8
3/4 EMT galvanized tubing for all the legs and later rails.
Video on how to change D9 pin to pin 44 5 volts
MPCNC Primo Build Ep. 12 Arduino Ramp...
Marlin Firmware page https://www.v1engineering.com/marlin-...
Credit goes to V1 Engineering for doing all the work. They sell all the parts to complete this build, you can just assemble one if you please.
https://www.v1engineering.com/
I don't go into all the details. Step by step instructions start here thanks to V1 Engineering. https://docs.v1engineering.com/mpcnc/...
Printed on a Creality Ender 3 0.4 nozzle, 60 mms, 0.28 layer height, gst3d and sunlu filament.
Files downloaded at https://www.thingiverse.com/thing:458...
Sliced with Cura 4.8
3/4 EMT galvanized tubing for all the legs and later rails.
3 سال پیش
در تاریخ 1399/11/11 منتشر شده
است.
7,779
بـار بازدید شده