Gemini Slider 12 volt sliding gate motor Expertly installed in Lyttelton Pretoria Pottie 083 7782288

Gemini Slider sliding gate motors are commonly used in Gauteng to automate steel sliding gates.
Gemini slider gate motors are normally used to automate residential properties as well as some business properties.
So if you want a professional, expert Gemini gate motor installer, then you need to Contact Pottie on 083 778 2288 for a professional installation.

Gemini sliders are manufactured locally in Silverton Pretoria by DMI Engineering.
This means that the Gemini slider gate motor parts are always available.
The Gemini slider gate motors are the 2nd generation of Gemini gate motors.

Gemini slider sliding gate motors are also commonly stolen.
A anti tamper bracket is normally fitted to prevent quick thefts of the Gemini gate motors.
a anti tamper bracket is not a theft deterrent bracket. Thus the need is there to improve the current anti tamper bracket.

This is where Exquisite Security goes the extra mile in preventing thefts of their gate motors they install.
The gate motor serial number, clients address and cell contact number is engraved on all the parts of the gate motor where possible.
Steel plates are also welded between the anti tamper bolt bracket and the steel base plate of the gate motor.
This means, the gate motor can not be unbolted and stolen quickly.
The only way to loosen the Gemini slider sliding gate motor is to cut the steel plates loose.

So, should the gate motor be stollen, one can trace the owner via the engraved detail.

The Gemini slider sliding gate motor is a 12 volt battery operated gate motor.
The gate motor runs off the 12 volt battery and only uses Eskom to charge the 12 volt battery.
A larger 12 volt 12 amp battery can be fitted into the gate motor.
The bigger 12 amp/ h battery allows for longer operation times during load shedding periods.
Or when heavy traffic "many daily openings and closings"

The Gemini slider sliding gate motor has a steel worm shaft which runs a plastic main gear.
The gearing system is a good combination, but it has been found that some users have managed to break, split the main gear on the gate motor.

The plastic main gear will normally split, when the steel sliding gate is forced open during a burglary by wedging in a object in between the steel sliding gate and gate pillar.
The other way to split the plastic main gear is to push the steel gate and while it is running, place the gate motor into gear.
the force generated is excessive and thus the main gear will split/ pop/ break.

To replace the main gear on a Gemini slider sliding gate motor can be done on site. It is time consuming as a complete unbolting of the gate motor is needed as access to the gearbox is from the bottom.

For more information, look here
https://www.exquisitesecurity.co.za/i...