HOW TO WIRE A TIMER TO A CONTACTOR

Timers are used to control loads, either to delay supply to the load when a switch is operated(On delay),  or to switch Off the load after a set period of time(Off delay).
when the load to be controlled needs a higher current to operate, the timer must be wired to operate the load through a contactor. in that case, the timer is only required to energize the contactor coil but the load current will be supplied through the contactor terminals. and that is what is demonstrated here in this video.

Two contactors were used; one for the "OFF delay" load(Amber lamp), and the other for the "ON delay" load(Green lamp).

I did a previous video which clearly shows how the timer works, and how to connect it for both "OFF delay" and "ON delay" functions, watch here HOW TO WIRE AN 8PIN TIMER FOR |"ON DE...

Please do well to subscribe, comment and share if you find this video useful thank you.
Star-delta starter |Complete wiring o...
HOW TO WIRE AN 8PIN TIMER FOR |"ON DE...
How to interlock two contactors | Com...
how to connect 3phase motor in star o...
Forward and reverse motor control com...
Complete wiring | Automatic changeove...
AUTOMATIC TRANSFER SWITCH 3phase Comp...
3phase motor winding connection at th...
How to check for open circuit in elec...
#1 Contactors explained | How contact...
AUTOMATIC TRANSFER SWITCH
#1 Direct-on-line Well Explained. | p...
#2 Direct-on-line control circuit Wel...
OVERLOAD RELAY CONNECTION EXPLAINED
1 Photo sensor +1 Contactor to power ...
Complete wiring | Automatic changeove...

@obloni_electrical

• #education
• #how_to_wire_a_timer_with_a_contactor
• #how_to_wire_a_timer_to_a_contactor
• #how_to_connector_a_timer_to_a_contactor
• #how_to_wire_a_contactor
• #timer_connection
• #contactor_connection
• #contactor_wiring
• #contactor_with_timer_wiring
• #how_to_wire_a_load_through_a_contactor
• #how_to_wire_a_contactor_with_a_timer
• #how_to_wire_a_contactor_to_a_timer
• #contactor
• #timer_switch
• #timer