How to Test an Engine Coolant Temperature Sensor - Using a Basic Multimeter
266.2 هزار بار بازدید -
10 سال پیش
-
Here is a quick video
Here is a quick video on how you can test your ECT Sensor using a basic multimeter.
You may find these other videos useful aswell:
How to Remove and Replace Inner and Outer Tie Rods: • How to Remove and Replace Inner and O...
How to Perform a parasitic draw test - Battery drain test: • How to Perform a Parasitic Draw Test ...
How to test your battery using a multimeter: • How to Test a Car Battery - Plus Tips...
How to replace a compressor clutch and bearing: • How to Remove and Replace an AC Compr...
If this video helped you out please don't forget to subscribe, give it a thumbs up or if you are feeling generous leaving a tip by clicking the " i " button on the top left corner of the screen. Thank you very much for your support!
Disclaimer:
Due to factors beyond the control of Ratchetsand Wrenches, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Ratchetsand Wrenches assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of my repair video's. Due to factors beyond the control of Ratchetsand Wrenches, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Again Any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video is the sole responsibility of the user and not Ratchetsand Wrenches.
10 سال پیش
در تاریخ 1393/07/28 منتشر شده
است.
266,282
بـار بازدید شده