[AP3D] How to use routing offsets (Set Route Line)
746 بار بازدید -
5 ماه پیش
-
#autocadplant3d
#autocadplant3d #piperouting #routingoffset #setrouteline
How to use routing offsets (Set Route Line)
Tip) 1. Viewport 2~3
2. + (Continuation grip) Pipe Extention (osnap mode : Shift+Right Click)
3. Compass (CTRL+Right Click)
4. Change Routing offset
Note :
Must check the Compass Plan :) before changing the Routing Offset (Set Route Line).
How to use routing offsets (Set Route Line)
Tip) 1. Viewport 2~3
2. + (Continuation grip) Pipe Extention (osnap mode : Shift+Right Click)
3. Compass (CTRL+Right Click)
4. Change Routing offset
Note :
Must check the Compass Plan :) before changing the Routing Offset (Set Route Line).
5 ماه پیش
در تاریخ 1402/11/08 منتشر شده
است.
746
بـار بازدید شده