[AP3D] Shop dwg - Welding Point Revision (Type , No. , Spool No.)
5.4 هزار بار بازدید -
2 سال پیش
-
#AutocadPlant3d
#AutocadPlant3d #PLANTWELDADD #PLANTWELDDISPLAY #shopdrawing
1. PLANTWELDDISPLAY : ON
SHOP / FIELD
2. PLANTWELDADD
Start Point of Pipe : PIPE End Point 를 선택 하면 않되고 끝부분에서 1mm 라도 떨어진 곳을 선택 해야함
(Do not select the pipe end. It should be selected at a distance of even 1mm from the end.)
Weld Ponit Move : Stretch
4. Welding No. Input , SPOOL No. Input
5. Isosetting
a. Iso style Setup
Create Iso Style (Copy Final_A2)
Maximum pipe length : OFF
SPOOL (Naming : Use spool number.... , Sizing : Use spool number...)
b.Annotations
Table ID's
Spool ID (ON)
Weld ID (Shop) - Block : Circle , ID:Weld Number Property
Weld ID (Field) - Block : Circle , ID:Weld Number Property
6. Iso Creation , Back Check!
1. PLANTWELDDISPLAY : ON
SHOP / FIELD
2. PLANTWELDADD
Start Point of Pipe : PIPE End Point 를 선택 하면 않되고 끝부분에서 1mm 라도 떨어진 곳을 선택 해야함
(Do not select the pipe end. It should be selected at a distance of even 1mm from the end.)
Weld Ponit Move : Stretch
4. Welding No. Input , SPOOL No. Input
5. Isosetting
a. Iso style Setup
Create Iso Style (Copy Final_A2)
Maximum pipe length : OFF
SPOOL (Naming : Use spool number.... , Sizing : Use spool number...)
b.Annotations
Table ID's
Spool ID (ON)
Weld ID (Shop) - Block : Circle , ID:Weld Number Property
Weld ID (Field) - Block : Circle , ID:Weld Number Property
6. Iso Creation , Back Check!
2 سال پیش
در تاریخ 1401/07/08 منتشر شده
است.
5,484
بـار بازدید شده