Harrison M300 lathe - apron drive seals, replacement & disassembly
1.2 هزار بار بازدید -
11 ماه پیش
-
The feed drive shaft runs
The feed drive shaft runs through a tube in the apron. That tube is supported by bronze bearings and sealed with shaft selas and O-rings. There are also thrust washers. This video covers disassembly of these components, replacing the seals, and reassembly.
00:00 Intro
04:49 Quick way to replace shaft seals
05:30 Full disassembly procedure
11:51 Wild goose chase
19:44 Disassembly continued
25:08 Inspecting the drive tube
29:48 Reassembly
Note: an oil channel runs up from the apron to the saddle. There should be an O-ring between the top of the apron and the underside of the saddle to prevent oil squeezing out there, although this is not shown on the parts diagram.
11 ماه پیش
در تاریخ 1402/08/06 منتشر شده
است.
1,266
بـار بازدید شده