MPCNC Primo Build Ep. 15 First Plasma cuts
5.6 هزار بار بازدید -
3 سال پیش
-
I am ready to try
I am ready to try and cut steel with my MPCNC Primo plasma cutter. I have the water table filled up and the slats welded on. I have some problems with the high frequency starts restarting the arduino. I work on the shielding try again.
My plasma cutter is a Eastwood Versa-Cut 40 and for air I have a Quincy QT-5 compressor.
Credit goes to V1 Engineering for doing all the work. They sell all the parts to complete this build, you can just assemble one if you please.
https://www.v1engineering.com/
I don't go into all the details. Step by step instructions start here thanks to V1 Engineering. https://docs.v1engineering.com/mpcnc/....
Printed on a Creality Ender 3 0.4 nozzle, 60 mms, 0.28 layer height, gst3d and sunlu filament.
Files downloaded at https://www.thingiverse.com/thing:458....
Sliced with Cura 4.8
3/4 EMT galvanized tubing for all the legs and later rails.
My plasma cutter is a Eastwood Versa-Cut 40 and for air I have a Quincy QT-5 compressor.
Credit goes to V1 Engineering for doing all the work. They sell all the parts to complete this build, you can just assemble one if you please.
https://www.v1engineering.com/
I don't go into all the details. Step by step instructions start here thanks to V1 Engineering. https://docs.v1engineering.com/mpcnc/....
Printed on a Creality Ender 3 0.4 nozzle, 60 mms, 0.28 layer height, gst3d and sunlu filament.
Files downloaded at https://www.thingiverse.com/thing:458....
Sliced with Cura 4.8
3/4 EMT galvanized tubing for all the legs and later rails.
3 سال پیش
در تاریخ 1399/12/22 منتشر شده
است.
5,690
بـار بازدید شده