Restoring an old Italian design 1930 gun | gun restoration
117.8 هزار بار بازدید -
12 ماه پیش
-
EVERYBODY PLEASE SUBSCRIBE TO THIS
EVERYBODY PLEASE SUBSCRIBE TO THIS CHANNEL AND MAKE SURE TO HIT THAT LIKE BUTTON LETS GET 10K LIKES ON THIS VIDEO
IMPORTANT NOTE:
I had made a full detail video on the process of hot bluing click on the link below
how to do the bluing process of your ...
CHAPTERS:
INTRODUCTION: 00:00
DISASSEMBLING: 00:40
REMOVING RUST: 06:25
CLEANING BARREL: 09:16
CLEANING SKREWS: 11:43
COLD BLUING SKREWS: 12:49
HOT BLUING GUN: 13:06
ASSEMBLING: 14:21
BOUGHT SOME GRIPS: 19:03
FINISHED REVIEW: 20:23
PROCESS:
The gun restoring process starts with lubricating the gun with DW40 to make sure it’s easy to disassemble after that the gun is completely disassemble and kept in rust removing liquid for 24 hours.
Once the rust became soft then a soft wire soft brush is used to clean the rust completely after that every part of the firearm in inspected to make sure its 100% working once all the parts are okay then the bluing process starts, every small part like screws are cold blued while the rest of the gun In blued through hot bluing once its blued then the gun is assembled again and lubricated perfectly and it’s good to use.
THANK YOU SO MUCH FOR WATCHING THIS VIDEO I HOPE YOU LIKE IT LEMME KNOW IN THE COMMENTS SECTION
IMPORTANT NOTE:
I had made a full detail video on the process of hot bluing click on the link below
how to do the bluing process of your ...
CHAPTERS:
INTRODUCTION: 00:00
DISASSEMBLING: 00:40
REMOVING RUST: 06:25
CLEANING BARREL: 09:16
CLEANING SKREWS: 11:43
COLD BLUING SKREWS: 12:49
HOT BLUING GUN: 13:06
ASSEMBLING: 14:21
BOUGHT SOME GRIPS: 19:03
FINISHED REVIEW: 20:23
PROCESS:
The gun restoring process starts with lubricating the gun with DW40 to make sure it’s easy to disassemble after that the gun is completely disassemble and kept in rust removing liquid for 24 hours.
Once the rust became soft then a soft wire soft brush is used to clean the rust completely after that every part of the firearm in inspected to make sure its 100% working once all the parts are okay then the bluing process starts, every small part like screws are cold blued while the rest of the gun In blued through hot bluing once its blued then the gun is assembled again and lubricated perfectly and it’s good to use.
THANK YOU SO MUCH FOR WATCHING THIS VIDEO I HOPE YOU LIKE IT LEMME KNOW IN THE COMMENTS SECTION
12 ماه پیش
در تاریخ 1402/05/19 منتشر شده
است.
117,839
بـار بازدید شده