Carrera Vengeance Throttle Mod using an Arduino
4.3 هزار بار بازدید -
پارسال
-
This is a quick one
This is a quick one just showing how the Arduino is connected to the bike.
I take no credit for this code, this was compiled by the folks over at https://www.pedelecs.co.uk/
There is not a lot of room to work with so this can get difficult.
- You need to know how to solder
- You will need a basic understanding of Arduino
- I take no responsibility if you break your bike.
This is a pretty easy mod. Just follow the diagram, the wire colours should match up if you have the 2021 version. This might also apply to others.
I have been running this for 7 months now with no failures.
Please leave any questions in the comments.
I take no credit for this code, this was compiled by the folks over at https://www.pedelecs.co.uk/
There is not a lot of room to work with so this can get difficult.
- You need to know how to solder
- You will need a basic understanding of Arduino
- I take no responsibility if you break your bike.
This is a pretty easy mod. Just follow the diagram, the wire colours should match up if you have the 2021 version. This might also apply to others.
I have been running this for 7 months now with no failures.
Please leave any questions in the comments.
پارسال
در تاریخ 1402/02/23 منتشر شده
است.
4,312
بـار بازدید شده