Lure DIY - Do this to your Snapper Slider Jig / Kabura Jig before using it
976 بار بازدید -
3 ماه پیش
-
A quick DIY showing how
A quick DIY showing how to prevent your Jig from breaking off after 1st use...
Items needed:
Pair of Scissors
Thin Metal wire (to go through beads)
Rubber beads (any color)
Small Zip Ties
Steps:
Step 1: Remove Split ring and slide weigh out
Step 2: Locate the string holding the rubber skirt
Step 3: Install zip tie above string then cut excess
Step 4: Cut the bead in half
Step 5: Feed the metal string through the line and then through the 1st half of bead, to sit it on top of zip tie
Step 6: Feed the weigh back through
Step 7: Feed the 2nd half of the bead on top of the weigh
Step 8: Retie the Split Ring
Tested and working wonders
hope you enjoy
like, comment and subscribe
PEACE
#fishingaustralia #sydneyfishing #diyfishing
Items needed:
Pair of Scissors
Thin Metal wire (to go through beads)
Rubber beads (any color)
Small Zip Ties
Steps:
Step 1: Remove Split ring and slide weigh out
Step 2: Locate the string holding the rubber skirt
Step 3: Install zip tie above string then cut excess
Step 4: Cut the bead in half
Step 5: Feed the metal string through the line and then through the 1st half of bead, to sit it on top of zip tie
Step 6: Feed the weigh back through
Step 7: Feed the 2nd half of the bead on top of the weigh
Step 8: Retie the Split Ring
Tested and working wonders
hope you enjoy
like, comment and subscribe
PEACE
#fishingaustralia #sydneyfishing #diyfishing
3 ماه پیش
در تاریخ 1403/02/21 منتشر شده
است.
976
بـار بازدید شده