ECU REPAIR TIPS (part 6) ujanja Establishing the, Data & Power Lines!
601 بار بازدید -
2 سال پیش
-
As we fully discussed, the
As we fully discussed, the ECU's behavior due to VCC1 at the front module being of overvoltage is different, compared to trigger failures. So, including all the voltages, 5V, 3.3V, 3V, etc, all better be catered for!
In order to avoid device damage during debugging or programming of the ECU, it is recommended to handle the ECU in a “controlled” production environment to ensure hakuna tatizo!
If this cannot be ensured, that standard resistor resistor between FO3/TEST pins and the connector ni lazima!
On http://www.5021.tips/ujanja/ecu as You download the whole jogolize bump, on chapter 4 of the input module, take all so you compare!
#5021Tips #onlinecourses #hapaujanjatu
In order to avoid device damage during debugging or programming of the ECU, it is recommended to handle the ECU in a “controlled” production environment to ensure hakuna tatizo!
If this cannot be ensured, that standard resistor resistor between FO3/TEST pins and the connector ni lazima!
On http://www.5021.tips/ujanja/ecu as You download the whole jogolize bump, on chapter 4 of the input module, take all so you compare!
#5021Tips #onlinecourses #hapaujanjatu
2 سال پیش
در تاریخ 1401/04/03 منتشر شده
است.
601
بـار بازدید شده