Ford 9" Rear End Rebuild with Yukon Gear Parts and Posi Traction!
107.8 هزار بار بازدید -
9 سال پیش
-
What a lovely day...to assemble
What a lovely day...to assemble the rear axle housing for the 73 Mustang!
I had ordered the parts from Yukon Gear and Axle a while ago but didn't have the press to complete the installation. I took everything to a local shop to have it assembled and that was taking too long. So I went to Harbor Freight and bought a press and decided to do it myself.
In this video, I press new bearings and wheel studs onto the new 31 spline axles and then cut them to fit the stock housing... Which gets a new set of end seals as well. I had already welded the new suspension brackets on and painted the housing when the Total Control Products Rear Coil Over Conversion system was installed.
http://www.totalcontrolproducts.com/g...
The center section is from Yukon Gear and Axle and is based on the Nodular Iron Dropout stuffed with a heavy duty True Trac Posi-traction and a 3.50 Ring Gear. I was going to use a 3.89 ratio but Kyle at Yukon recommended a 3.50 since the car was going to be used for Autocross...he says I'll be thankful for that few hundred RPM drop when I'm doing long second gear pulls dodging cones...so thanks for the help! https://www.yukongear.com/
So check out the video and don't forget to share and subscribe to help keep me going!
Thanks for watching,
Jason
#ford #9inch #yukon
I had ordered the parts from Yukon Gear and Axle a while ago but didn't have the press to complete the installation. I took everything to a local shop to have it assembled and that was taking too long. So I went to Harbor Freight and bought a press and decided to do it myself.
In this video, I press new bearings and wheel studs onto the new 31 spline axles and then cut them to fit the stock housing... Which gets a new set of end seals as well. I had already welded the new suspension brackets on and painted the housing when the Total Control Products Rear Coil Over Conversion system was installed.
http://www.totalcontrolproducts.com/g...
The center section is from Yukon Gear and Axle and is based on the Nodular Iron Dropout stuffed with a heavy duty True Trac Posi-traction and a 3.50 Ring Gear. I was going to use a 3.89 ratio but Kyle at Yukon recommended a 3.50 since the car was going to be used for Autocross...he says I'll be thankful for that few hundred RPM drop when I'm doing long second gear pulls dodging cones...so thanks for the help! https://www.yukongear.com/
So check out the video and don't forget to share and subscribe to help keep me going!
Thanks for watching,
Jason
#ford #9inch #yukon
9 سال پیش
در تاریخ 1394/03/22 منتشر شده
است.
107,836
بـار بازدید شده