How To: Transfer Case Fluid Change (2005 - 2010) Jeep Grand Cherokee WK
37 هزار بار بازدید -
6 سال پیش
-
Instructions down belowThis video demonstrates
Instructions down below
This video demonstrates how to change the fluid in a Transfer Case
Step 1: Locate transfer case
Step 2: Inspect and make sure the tools that are required are on hand
Step 3: Remove weight if needed
Step 4: Locate highest bolt to remove first before the drain bolt
Step 4: Remove lowest bolt to drain the fluid. Reinstall bolt to pour in fluid and stop when fluid starts to come out
Step 5: Reinstall all other bolts and weight (if needed)
Done
If possible, please leave some effective criticism so that I am able to improve and proceed to be better next time!
Disclaimer:
Due to factors beyond the control of Motor Mech, I cannot guarantee against improper use or unauthorized modifications of this information. Motor Mech assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Motor Mech recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Motor Mech, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Motor Mech.
Any product names, logos, brands, or other trademarks or images featured or referred to within the Motor Mech video are the property of their respective trademark holders. These trademarks are not affiliated with Motor Mech. The respective trademark holders do not sponsor or endorse Motor Mech.
This video demonstrates how to change the fluid in a Transfer Case
Step 1: Locate transfer case
Step 2: Inspect and make sure the tools that are required are on hand
Step 3: Remove weight if needed
Step 4: Locate highest bolt to remove first before the drain bolt
Step 4: Remove lowest bolt to drain the fluid. Reinstall bolt to pour in fluid and stop when fluid starts to come out
Step 5: Reinstall all other bolts and weight (if needed)
Done
If possible, please leave some effective criticism so that I am able to improve and proceed to be better next time!
Disclaimer:
Due to factors beyond the control of Motor Mech, I cannot guarantee against improper use or unauthorized modifications of this information. Motor Mech assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Motor Mech recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Motor Mech, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Motor Mech.
Any product names, logos, brands, or other trademarks or images featured or referred to within the Motor Mech video are the property of their respective trademark holders. These trademarks are not affiliated with Motor Mech. The respective trademark holders do not sponsor or endorse Motor Mech.
6 سال پیش
در تاریخ 1397/04/10 منتشر شده
است.
37,081
بـار بازدید شده