Nissan P0507 Idle Control System - Idle Relearn Procedure
656 هزار بار بازدید -
8 سال پیش
-
This Nissan Murano had a
This Nissan Murano had a code P0507 after performing other repairs and cleaning out the throttle body. This particular code basically means that the RPM are higher then expected probably from an intake/vacuum leak or something like that.But in this case I was almost sure that it was caused because we cleaned the throttle body. so this is how you do the relearn of the idle control system.
if you want to help out the channel, just use my Amazon link when sopping at amazon.
https://amzn.to/2KEtHCp
*RE-LEARN PROCEDURE STEPS*
Idle Air, Volume Learn.
1. Make sure the accelerator pedal is fully released.
2. Turn ignition ON, do not start engine, then wait 3 seconds turn the ignition back off and wait 10 sec.. redo this procedure 3 times
3. Next, Fully depress and release the accelerator pedal 5x within 5 seconds
4. Wait 5 seconds, then fully depress and hold accelerator pedal. After Approximately 10 seconds, the Malfunction indicator light will switch from steady to blinking. Approximately 9 seconds later, the light changes from blinking to steady once again.
5. Fully release accelerator pedal and start the car within 3 seconds.
6. Allow to idle. Wait 20 seconds.
Hope it help some one out there. Don't forget to SUB!!!
If you would like to leave a donation here is a link ...
https://www.paypal.com/cgi-bin/webscr...
Follow me on INSTAGRAM
Instagram: falcons_hobbies
Twitter.
Twitter: shospeed
Facebooks Hobbies
Facebook: falconshobbies
My Gaming Channel.
@falconsgaming
The information presented in this program is based on a specific diagnostic case and might not directly apply to the vehicle you are repairing. We do not represent or warrant that the information presented is complete or error free. Please take all safety precautions. We disclaim any and all liability for losses, injuries or damages in connection with your repair."
if you want to help out the channel, just use my Amazon link when sopping at amazon.
https://amzn.to/2KEtHCp
*RE-LEARN PROCEDURE STEPS*
Idle Air, Volume Learn.
1. Make sure the accelerator pedal is fully released.
2. Turn ignition ON, do not start engine, then wait 3 seconds turn the ignition back off and wait 10 sec.. redo this procedure 3 times
3. Next, Fully depress and release the accelerator pedal 5x within 5 seconds
4. Wait 5 seconds, then fully depress and hold accelerator pedal. After Approximately 10 seconds, the Malfunction indicator light will switch from steady to blinking. Approximately 9 seconds later, the light changes from blinking to steady once again.
5. Fully release accelerator pedal and start the car within 3 seconds.
6. Allow to idle. Wait 20 seconds.
Hope it help some one out there. Don't forget to SUB!!!
If you would like to leave a donation here is a link ...
https://www.paypal.com/cgi-bin/webscr...
Follow me on INSTAGRAM
Instagram: falcons_hobbies
Twitter.
Twitter: shospeed
Facebooks Hobbies
Facebook: falconshobbies
My Gaming Channel.
@falconsgaming
The information presented in this program is based on a specific diagnostic case and might not directly apply to the vehicle you are repairing. We do not represent or warrant that the information presented is complete or error free. Please take all safety precautions. We disclaim any and all liability for losses, injuries or damages in connection with your repair."
8 سال پیش
در تاریخ 1394/12/21 منتشر شده
است.
656,063
بـار بازدید شده