NUTRIBULLET. CHANGING THE TWO BEARINGS
85.6 هزار بار بازدید -
9 سال پیش
-
http://simplybearings.co.uk/shop/p914... This is the link to the bearings I used in this video. they came out at £3.08 each less postage. Total cost was £7.39 for two including post. When you put the screw driver through the top seal, you side it down until you can feel the top bearing and then tap it out ! When putting every thing back I use coconut oil, which is more like lard to look at on the seals & shaft of the blade before I put it back. You can get skf on this site but these bearings are more expensive ! Also, I do not put this base and blade assembly in the dish washer. they are so easy to rinse under the tap anyway ! Just put the six sided cutter back into this base with these new bearings, so will feed back on how they hold up ! Removing Blade. check this out. Nutribullet extractor blade replacement
9 سال پیش
در تاریخ 1394/12/20 منتشر شده
است.
85,612
بـار بازدید شده