EG4 6000XP and EG4 PowerPro Battery Generator

This build is intended to be a UPS and back up generator system for my critical load panel. 

I am using the EG4 6000XP inverter and EG4 PowerPro battery. I purchased both from Signature Solar.

I didn’t want to make this a “permanent installation” thus the cart. This cart construction is very sturdy. As mentioned in the video I purchased the 80/20 8080 type extrusion from Amazon and some from Automation Direct. If I was to do it over again I would probably purchase all the extrusion from automation direct because it’s free two day shipping on orders over $50 and  slightly less expensive for the extrusion pieces than Amazon. With automation direct you also have the ability to have custom cut lengths of the extrusion that you can order with no additional charge. On Amazon you only have a few choices of cut lengths available to order, nothing custom.

This video is not sponsored by anyone. 

Some links to some of the items:
https://www.amazon.com/dp/B0BS93KXD9?...
https://www.amazon.com/dp/B0CBQ7RCD1?...
https://www.amazon.com/dp/B0CB6Q19XX?...
https://www.amazon.com/dp/B08PVFLFSR?...
https://www.amazon.com/dp/B07QV7RZ6W?...