SSB in experimental receiver with TEF6686 (87)
991 بار بازدید -
11 ماه پیش
-
Although the IC TEF6686 (87)
Although the IC TEF6686 (87) does not have SSB demodulation (only AM and FM) it is possible to listen to amateur radio stations transmitting in SSB (single side band) with the help of a digital BFO. In this case I am using tinySA in RF generator mode.
The tinySA generator must be adjusted to the same frequency at which the SSB signal is being transmitted and allows fine adjustment in steps of 10kHz and the signal amplitude. The tinySA uses a small antenna to transmit the carrier to the regenerative receiver.
In the setup I use a tuner with the TEF6687 (or 86) and an Arduino Uno to control it.
73!
The tinySA generator must be adjusted to the same frequency at which the SSB signal is being transmitted and allows fine adjustment in steps of 10kHz and the signal amplitude. The tinySA uses a small antenna to transmit the carrier to the regenerative receiver.
In the setup I use a tuner with the TEF6687 (or 86) and an Arduino Uno to control it.
73!
11 ماه پیش
در تاریخ 1402/08/06 منتشر شده
است.
991
بـار بازدید شده