Genesis Coupe 2.0T Engine Build Pt.1 | Crankshaft and Oil Clearances

700WHP Engine Refresh Build Part1:

How to install crankshaft, bearings, main caps, arp studs, thrust washers, check oil clearances.

Aftermarket Internals:
*ACL Main and Rod Bearings Extra Oil Clearance - https://gencoupestore.com
*K1 Rods (Comes w/ ARP2000 Bolts) - https://www.google.com/amp/s/www.genr...
*Wiseco Oversized Pistons - https://www.genracer.com/wiseco-overs...
*Thrust Bearings - Gencoupe Store or Hyundai Dealership
*Arp Main Stud Kit - https://www.khartunerz.com/ARP-Main-S...
*Machine Work  - Longs Machine Shop San Antonio Texas. Aligned Honed / Port Flushed / Acid Bath / Rotating Assembly Balanced / Crankshaft Polished / Bored out .05 / Piston to Wall Clearance Checked

Tools Used:
*11mm 12 point socket
*5/8 12 point socket
*Torque wrench
*Breaker Bar
*Size 4 Hex
*Assembly Lube
*ARP fastener assembly lube
*Plasti Gauge
*ATF w/ Blue shop towels


I did forget to mention that the torque for the main bolts is 70lbs of torque
You do this in a sequence of 3 times
23lbs first pass
47lbs second pass
70lbs third pass

I also forgot to mention to use assembly lube on the journals after the plasti gauge step. You NEED assembly lube before doing the final torque settings or else you might damaged the bearings on first start up.

If you guys like this video please share / subscribe and drop a like below. Sorry I’ve been slacking on my videos times are really tough as I struggle to find yet another job after being laid off thanks to the pandemic.

Stay safe and enjoy the video!