Measuring Cables with the FPC

Rohde Schwarz
Rohde Schwarz
522 بار بازدید - 2 ماه پیش - This video demonstrates how to
This video demonstrates how to make basic measurements of coaxial cables using VNA mode on the Rohde & Schwarz FPC1500 analyzer.

Learn more about the R&S FPC: https://www.rohde-schwarz.com/us/prod...
Maximise analysis with the Rohde & Schwarz Vector Network Analyzers: https://www.rohde-schwarz.com/us/prod...
Download the Fundamentals of Vector Network Analysis Primer: https://www.rohde-schwarz.com/us/prod...

Timeline:
00:00 Introduction
00:15 Suggested viewing
00:29 About cable measurements
01:41 Two ways to measure cables with the FPC1500
02:07 About 1-port cable loss measurements
02:48 Steps in 1-port cable measurements
03:13 Starting VNA mode – 1 port cable loss
03:31 Configuring the source (tracking generator)
04:13 Defining the frequency range
04:50 Measurement setup – direct vs. DUT cable
05:32 About one port calibration
06:24 Connecting calibration standards for 1 port measurements
06:56 Choosing cable measurement (termination) type
07:39 Measurement results – Cable loss (open)
08:01 Measurement results – Cable loss (short + open) / 2
08:40 When to use a transmission (S21) measurement for cable loss
09:14 Steps in 2-port cable measurements
09:39 Starting VNA mode - transmission S21
09:47 Measurement setup – transmission/normalization
10:26 Two-port (S21) cable measurement result
10:41 Using markers
11:11 Summary
2 ماه پیش در تاریخ 1403/04/21 منتشر شده است.
522 بـار بازدید شده
... بیشتر