Seymour Duncan P90 Stacks

Jack Fossett
Jack Fossett
42 هزار بار بازدید - 7 سال پیش - Gibson SG Classic with Seymour
Gibson SG Classic with Seymour Duncan P90 Stack Noiseless Soapbar Pickups into a Marshall Bluesbreaker JTM45
Subscribe here: http://www.youtube.com/subscription_c...
http://www.jackfossett.com/
Facebook: jackfossett

This was a sponsored review, however, the opinions expressed were entirely of my own volition.

Disclaimer: I do basic audio editing on my videos to account for the microphones, preamp and room. This editing, mostly light EQ and compression, is intended to give you the most accurate representation of how the featured gear actually sounds. NO editing is done to misrepresent how the featured gear sounds in any way.
Description
Our P90 Stack delivers a noiseless, vintage style, P90 soapbar tone for any guitar with a P90 sized pickup route. You get the growl and sparkle, but none of the pesky hum that traditional single coils have. The bridge model sounds nice and midrangy, with just the right amount of grit. The 4-conductor lead wire gives you the option to split the coils if you want, or to switch into series mode for a more compressed sound. At .95 in height, this pickup is a little taller than a typical P90, so you may want to make sure your guitars pickup slots are deep enough before trying to install them. Pair with our P90 Stack neck model for a matched set.Hand built in Santa Barbara, CA, the P90 Stack uses dual Alnico 5, 4-conductor lead wire, and is vacuum wax potted for squeal free operation.
7 سال پیش در تاریخ 1396/04/05 منتشر شده است.
42,037 بـار بازدید شده
... بیشتر