The fastest way to cut radii on YouTube?
4 هزار بار بازدید -
6 ماه پیش
-
This method uses the tool
This method uses the tool shank as a stop to position the desired radius centre over the rotary table centre.
Swapping between a smaller stop pin & the cutter will enable rads to be cut inside the perimeter of the block.
It is also possible to use the spindle boss as a stop if there is sufficient clearance, this enables the tool to remain in the spindle.
Swapping between a smaller stop pin & the cutter will enable rads to be cut inside the perimeter of the block.
It is also possible to use the spindle boss as a stop if there is sufficient clearance, this enables the tool to remain in the spindle.
6 ماه پیش
در تاریخ 1402/12/04 منتشر شده
است.
4,081
بـار بازدید شده