P2565 turbocharger boost control position sensor circuit high 2014 Santa Fe 2.0L instructions below
134.6 هزار بار بازدید -
5 سال پیش
-
How to adjust 2014 santa
How to adjust 2014 santa fe 2.0L turbo. Turbo lag.
Tools needed. Voltmeter set at DCV 20
10mm for bar nuts and connecting shaft to electric controller.
Adjustment is twist in. If reading higher than 4.1v. Specification is 4.0 +- 0.1V
Engine should be cold. And just turn to on. Not running. I started it after setting to 4.0v and blip throttle to recheck by pulling rod to see if still good reading.
Link to why this adjustment is needed. 2014 2.0 Hyundai santa fe limp mode h...
Tools needed. Voltmeter set at DCV 20
10mm for bar nuts and connecting shaft to electric controller.
Adjustment is twist in. If reading higher than 4.1v. Specification is 4.0 +- 0.1V
Engine should be cold. And just turn to on. Not running. I started it after setting to 4.0v and blip throttle to recheck by pulling rod to see if still good reading.
Link to why this adjustment is needed. 2014 2.0 Hyundai santa fe limp mode h...
5 سال پیش
در تاریخ 1398/08/09 منتشر شده
است.
134,655
بـار بازدید شده