Lathe Clutch Shaft Repair Part 1
182.3 هزار بار بازدید -
2 سال پیش
-
This will be a 2
This will be a 2 part series on repairing a worn and damaged clutch shaft out of a Colechester lathe. In part 1 I'll show welding up the drive end, bearing journal and keyway and getting it turned back to the proper specs. In part 2 we'll do a flame spray build up repair on the clutch end and mill the 10mm keyway. I'll also be putting to work some new Walter tooling and carbideI got in.
Paypal Channel Donation: https://www.paypal.com/cgi-bin/webscr...
Support though Patreon: Patreon: abom79
My Amazon store where I'm adding many of the tools and products I use in my own shop. Amazon.com/shop/abom79
Visit my second Youtube channel where you can follow are travels, camping, RVing, cooking, and bbq!
Paypal Channel Donation: https://www.paypal.com/cgi-bin/webscr...
Support though Patreon: Patreon: abom79
My Amazon store where I'm adding many of the tools and products I use in my own shop. Amazon.com/shop/abom79
Visit my second Youtube channel where you can follow are travels, camping, RVing, cooking, and bbq!
2 سال پیش
در تاریخ 1401/01/20 منتشر شده
است.
182,368
بـار بازدید شده