JK Barricade Roof Rack Installation - Do Not Tighten Hardware

Mac, Jessica, friends and dogs install a Barricade Roof Rack from Extreme Terrain on our 2012 Jeep Wrangler JK. We opt for the frame mount on the rear for more capacity and so we don't have to drill holes in the body. All of this is in preparation for the arrival of a rooftop tent.

00:00 Unboxing and Intro
06:10 Step 1
08:08 Cutting the Neopreyne Pads
10:06 Step 2 Passender Side Front and Plastic Washers
12:36 Step 4 Driver Side Front and Oops
14:11 Backing Up
15:46 Mallet Time
16:58 Step 5 Side Bars and Second Mistake
18:26 Step 7 Rear Frame Tie Ins
19:58 Chasing Threads With a Tap
20:43 Mysterious Third Hole
21:35 Chasing the Backing Plate
23:18 Step 10 Driver Side Rear Frame and Third Mistake
23:50 Steps 11-13 And Don't Tighten the Hardware!
25:43 Backing up on the Driver Side Frame Mount
28:09 Backing up on the Passenger Side Frame Mount
30:25 Steve to the Rescue
31:55 Struggling with Lining up Bolts
33:39 Discovering the Cross Bars Don't Line Up With the Side Bars
34:34 Taking Off the Front to Swap the Side Bars
36:30 Crossbar Bolts and Collapsing Steps
38:13 Now You Can Tighten All the Hardware
38:53 65mm Versus 80mm Bolts
39:24 Wind Noise Tests and First Drive

##outdoors #roofrack  #vlog #youtube #nature  #summer #jeep ‪@extremeterrain‬