How to Clean and Calibrate a Jobsite Tablesaw - Tablesaw Tune-up and Maintenance
76.9 هزار بار بازدید -
4 سال پیش
-
Dial Indicator Jig: www.etsy.com/listing/1057047159Dial Gage
Dial Indicator Jig: www.etsy.com/listing/1057047159
Dial Gage Indicator: https://amzn.to/3BCElnR
John White Book: https://amzn.to/3qX6ErB
Today I go over the essential steps for cleaning and calibrating a jobsite tablesaw. Note that while the steps taken are general to all saws, the calibration methods will be different for each manufacturer. A final step that was not shown is to ensure that the fence is perpendicular to the table. I skipped this as mine is slightly off and am in the process of getting a new fence (there's no built in way to calibrate this unfortunately). Be sure to subscribe and stay tuned for more content.
Check out my favorite tools/gear here: https://www.amazon.com/shop/thetranq
Website: https://holdentranquillo.wixsite.com/...
Dial Gage Indicator: https://amzn.to/3BCElnR
John White Book: https://amzn.to/3qX6ErB
Today I go over the essential steps for cleaning and calibrating a jobsite tablesaw. Note that while the steps taken are general to all saws, the calibration methods will be different for each manufacturer. A final step that was not shown is to ensure that the fence is perpendicular to the table. I skipped this as mine is slightly off and am in the process of getting a new fence (there's no built in way to calibrate this unfortunately). Be sure to subscribe and stay tuned for more content.
Check out my favorite tools/gear here: https://www.amazon.com/shop/thetranq
Website: https://holdentranquillo.wixsite.com/...
4 سال پیش
در تاریخ 1399/03/06 منتشر شده
است.
76,926
بـار بازدید شده