How to Increase Hot Water Capacity

If you run out of hot water quickly, buying a new water heater is not your only option. Learn how to extend the life of your water heater with a Cash Acme Tank Booster PRO thermostatic mixing valve (TMV) and SharkBite Max connector. Follow as David Hunt, a master plumber of 35 years, installs the TMV onto the water heater, properly adjusts the hot water temperature and explains some best practices. See below for important instructions for a safe, reliable and efficient installation.*
Featured products:
Tank Booster Pro Thermostatic Mixing Valve, Flexible Connector, Water Heater Tee and Temperature Guage: https://bit.ly/3RPQcK9
Max Brass Push Corrugated Water Heater Connector with Ball Valve: https://bit.ly/3NCr2fo

More on SharkBite Max: https://bit.ly/3vgQgJV
Subscribe for more videos like this: ‪@SharkBitePlumbing‬

Follow us on social:  
Instagram: Instagram: sharkbiteplumbing  
Facebook: Facebook: SharkBitePlumbingSolutions  
LinkedIn: LinkedIn: sharkbite  
Website: https://www.sharkbite.com/us/en  

0:00 Introduction  
0:50 Shut-off and Draining Information
3:00 Tank Booster Assembly
4:04 Prep the Pipe
5:38 Galvanized Nipples
7:14 Adapter and Mixing Valve
8:08 Tee and Connector
9:10 How the System Works
9:58 Cold-side Install
12:38 Hot-side Install
13:46 Tighten the Connection
14:40 Let Air Out of the System
17:50 Adjust the Temperature  
20:15 Outro

#plumbing #howto #waterheater

*Water Heater Best Practices:
- Before installation, drain the water using a low point drain, such as a tub.  
- Use a ratchet cutter for CPVC pipe so it does not shatter.  
- Use dielectric unions when connecting dissimilar metals to avoid electrolysis.
- After installation, let the air out of the system by turning the water on. Ensure the power is off.  
- Turn the water on slowly with all faucets off, letting the tank fill with water.
- Ensure the power is off, then adjust the temperature of your water heater thermostat temperature to 140° F each.  
- After setting the new temperatures on the water heater, turn the power on to adjust the temperature to 120° F on the mixing valve. Use an Allen wrench and ensure the temperature remains constant.