20watt Fiber Laser Engraver, EasyCad2 Problems- Not firing - FIXED!!!
23.6 هزار بار بازدید -
6 سال پیش
-
Purchased a 20watt Fiber laser
Purchased a 20watt Fiber laser from Ebay and had some issues getting it running, The Video will show the problem i had from the beginning.
The Customer support was non existent but after a few days of surfing forms i finally found a solution.
Setting up the Parameters was one thing. Raycus Fiber laser is rely all i had to make sure I was set on. The Default parameters on the Right hand side of your screen can be changed by clicking the color blocks to adjust the basic parameters there
my issue was i was getting no heat or spark from the laser, The laser was not even hot enough to melt plastic.
So I went into the settings and made the work space ( Apparently this is the lenses size, i set that to 170mm ) Then i cranked the head of the laser to the highest height.
Once that was done I created a square in the work space and told the laser to mark this square. Once it was attempting to mark the square i then slowly lowered the head of the laser down and down until the unit became focused and Sparks started to fly.
This laser engraver works amazing now that i got it going. but it did take a long time to get working, So hopefully if someone has the same issues i did with basically just being a noob at this laser stuff, Heres hopping this will help you!
The Customer support was non existent but after a few days of surfing forms i finally found a solution.
Setting up the Parameters was one thing. Raycus Fiber laser is rely all i had to make sure I was set on. The Default parameters on the Right hand side of your screen can be changed by clicking the color blocks to adjust the basic parameters there
my issue was i was getting no heat or spark from the laser, The laser was not even hot enough to melt plastic.
So I went into the settings and made the work space ( Apparently this is the lenses size, i set that to 170mm ) Then i cranked the head of the laser to the highest height.
Once that was done I created a square in the work space and told the laser to mark this square. Once it was attempting to mark the square i then slowly lowered the head of the laser down and down until the unit became focused and Sparks started to fly.
This laser engraver works amazing now that i got it going. but it did take a long time to get working, So hopefully if someone has the same issues i did with basically just being a noob at this laser stuff, Heres hopping this will help you!
6 سال پیش
در تاریخ 1397/05/19 منتشر شده
است.
23,697
بـار بازدید شده