How to repair Vfd drive || vfd repairing tutorial|| vfd drive training || vfd repairing in Hindi
10.5 هزار بار بازدید -
3 سال پیش
-
hello everyone
in that video
hello everyone
in that video we are teaching how to repair vfd,in that video we will give full vfd repair training. We have vfd repairing lab where we will teach you how to repair vfd diy.we will teach you vfd repairing in Hindi/Urdu with complete practical, this is complete course for vfd repairing
The basic:
At first I would like you to understand, what is the main parts of a VFD.
1. The first is the bridge rectifier diodes. You see 4 diodes if your device is require one phase, or 6 diodes if it require 3 phase input.
2. In the middle you see an inductor and a capacitor for smoothing both the voltage and the current. It is called "DC - bus"
3. On the right side of the video , you can see the 3 phase IGBT bridge. The bridge contains 6 high power IGBTs.
Start the repair
At first you should not want to power up the drive, without you actually measured the power section! If you power up the inverter without you measured it and it has a short on the power section you may get a big surprise, so be careful.👹
From experience, I can define three most common fault, that VFDs have:
The most common problem comes from some people miss reading the sticker on the drive, what voltage is it require. With this move, they often kill the diode bridge and some input protection VDR (Varistor).
The second common problem is the condensators, what are the weakest component in the entire drive. The condensators life time is much shorter then any other parts in the drive, so if you repair any damaged VFD you should replace those as well.
The third problem is often come with the bad heat dissipation. If the IGBTs or the diodes get too hot, one, two, or even more go to short. This caused by the IGBT drive circuit fault, or the heat shock on the power section.
step 1 first you have to check power section with multimeter.
step2 if vfd is showing dead check charging resistor.
step3 check igbt module with multimeter.
step4 if vfd is on and give you some fault note fault and search it in vfd manual in warning and solution section
(Instagram)
www.instagram.com/irfangct1/
(Twitter)
twitter.com/IrfanIndustrial
(Facebook)
www.facebook.com/profile.php?id=100001723597857
(pinterest)
www.pinterest.com/irfangct/_saved/
(Linkedin)
www.linkedin.com/in/muhmmad-irfan-65813b222/
(whatsapp NUMBER)
+92345904846
3 سال پیش
در تاریخ 1400/07/03 منتشر شده
است.
10,527
بـار بازدید شده