Part 1a - DesignModeler for Vehicle Aerodynamics
81.1 هزار بار بازدید -
13 سال پیش
-
Part one of the series
Part one of the series of videos guiding you through CFD usage in external vehicle aerodynamics with ANSYS Workbench 13. Parts are going to be:
1. Geometry preparation using DesignModeler.
2. Mesh generation using ANSYS Meshing.
3. Case setup, solving and post-processing in ANSYS Fluent.
4. Post-processing and visualisation in ANSYS CFD-Post.
I'm sorry that the first part is split into a/b but it turned out 17 minutes long with me skipping things along the line. I will create a playlist of all files to make it easier on you guys.
P.S. I know 1080p is kind of "large", but I tried to record a tutorial in 1280x720 and the workspace was reduced so drastically that half the menus weren't visable and there would've been a lot of zooming and stretching for me in post processing of the video, so.. since I'm not getting any richer by doing this you can suffer in silence! :)
1. Geometry preparation using DesignModeler.
2. Mesh generation using ANSYS Meshing.
3. Case setup, solving and post-processing in ANSYS Fluent.
4. Post-processing and visualisation in ANSYS CFD-Post.
I'm sorry that the first part is split into a/b but it turned out 17 minutes long with me skipping things along the line. I will create a playlist of all files to make it easier on you guys.
P.S. I know 1080p is kind of "large", but I tried to record a tutorial in 1280x720 and the workspace was reduced so drastically that half the menus weren't visable and there would've been a lot of zooming and stretching for me in post processing of the video, so.. since I'm not getting any richer by doing this you can suffer in silence! :)
13 سال پیش
در تاریخ 1390/12/11 منتشر شده
است.
81,118
بـار بازدید شده