How to make programming BFT gate remote using old remote
128.5 هزار بار بازدید -
7 سال پیش
-
REMOTE TO REMOTE PROGRAMMING,
If
REMOTE TO REMOTE PROGRAMMING,
If the programming is locked inside the gate machine control board, this method will not work, you need to open the gate machine and control unit, there is a DIP switch, set the DIP switch No:6 to 'ON' mode, then try the same programming method , new remote should be work.
BFT Remotes Sales in Dubai, UAE
Cont : Eng. Ahmed Nizar
Call/ WhatsApp : +97152 9458166
[email protected].
The New remote controls must be programmed to be used otherwise they will NOT work. Please carefully watch this video and the instructions here to program the BFT remote control.
1. You must stand close to the gate or garage door (near the receivers) with both remote controls, the old one that works and the new one. In the video, the old one is the one with the white tape on it.
2. Press both buttons on the old one until the LED lights up. When the led lights up, Leave both buttons. Then just press the button you normally use to open the gate until the LED lights up.
3. Take the new remote control and press both buttons in the same way until the LED lights up.
4. Then press any button that you will wish to use to open the gate.
5. Wait at least 10-20 seconds to try the new remote control.
PEOPLE THANK YOU SO MUCH FOR WATCHING MY VIDEO!
Please like this video if you find helpful :)
7 سال پیش
در تاریخ 1396/02/17 منتشر شده
است.
128,598
بـار بازدید شده