Meshing the clearance between Blade Tip and Outer Air Seal | Axial flow turbines
188 بار بازدید -
9 ماه پیش
-
We will be meshing the
We will be meshing the gap between the Blade and the shroud mainly focusing on the tip clearance. The geometry is of the Outer Air Seal of a Axial flow turbine.
00:00 - 00:34 Introduction
00:34 - 03:33 2D Topology
03:33 - 05:31 Wrap
05:31 - 07:53 Assignment
07:53 - 08:30 Validity Check
08:30 - 09:55 Balancing Density
09:55 - 12:12 Addressing Mildly Severe Singularity
12:12 - 12:26 Assignment
12:26 - 12:48 Internal Wrap
12:48 - 13:40 Ggrid
13:40 - 15:10 Balancing Density
15:10 - 16:00 Ggrid
If you have any comments, questions, or suggestions, then drop a line below. You could also connect with us on Twitter, LinkedIn or on Facebook.
Twitter: Twitter: GridPromesh
Facebook: Facebook: GridProCFD
LinkedIn: LinkedIn: 1808124
00:00 - 00:34 Introduction
00:34 - 03:33 2D Topology
03:33 - 05:31 Wrap
05:31 - 07:53 Assignment
07:53 - 08:30 Validity Check
08:30 - 09:55 Balancing Density
09:55 - 12:12 Addressing Mildly Severe Singularity
12:12 - 12:26 Assignment
12:26 - 12:48 Internal Wrap
12:48 - 13:40 Ggrid
13:40 - 15:10 Balancing Density
15:10 - 16:00 Ggrid
If you have any comments, questions, or suggestions, then drop a line below. You could also connect with us on Twitter, LinkedIn or on Facebook.
Twitter: Twitter: GridPromesh
Facebook: Facebook: GridProCFD
LinkedIn: LinkedIn: 1808124
9 ماه پیش
در تاریخ 1402/07/17 منتشر شده
است.
188
بـار بازدید شده