Edgerouter X First Time Setup

In this video, I go over how to configure an Edgerouter-X for the first time. If you don't quite know how to get your internet up and running with the ER-X just follow the steps in this video and get it running in no time. Hardware Offload Commands: (ER-X, ER-10X, EP-R6, ER-X-SFP) configure set system offload hwnat enable set system offload ipsec enable commit save Hardware Offload Commands for Cavium-based devices (ER-6P, ER-4, ERLite-3, etc...). The commands are slightly different for different models. If the above commands do not take with your specific model, try these. configure set system offload ipv4 forwarding enable set system offload ipv4 gre enable set system offload ipv4 pppoe enable set system offload ipv4 vlan enable set system offload ipv4 bonding enable set system offload ipv6 forwarding enable set system offload ipv6 pppoe enable set system offload ipv6 vlan enable set system offload ipsec enable commit save

• #education
• #edgerouter
• #networking
• #home_networking
• #ubiquiti
• #internet
• #router
• #configuration
• #setup