Delphi DCM 3.2 using Ktag BDM
39.1 هزار بار بازدید -
8 سال پیش
-
In this case it was
In this case it was a Ssangyong Roduis 2.7 diesel vehicle. But same procedure applies for Kia and Lada, NOT for Mercedes even if ecu is very similar.
Please pay attention to entire video as it contains very important details.
Sometimes depending on tool OBD read requires reading two data banks and OBD reads only one but when wrtitting it will erase both and write only one of them. Car will start but wont pass 1500rpm. So i strongly recommend reading via BDM backup and maps.
Please pay attention to entire video as it contains very important details.
Sometimes depending on tool OBD read requires reading two data banks and OBD reads only one but when wrtitting it will erase both and write only one of them. Car will start but wont pass 1500rpm. So i strongly recommend reading via BDM backup and maps.
8 سال پیش
در تاریخ 1395/09/29 منتشر شده
است.
39,195
بـار بازدید شده