How to make a DIY action camera (use an old phone)
400.8 هزار بار بازدید -
9 سال پیش
-
Fisheye Lens:
Fisheye Lens: http://amzn.to/1LMtJVI
Hook & Loop Strap: http://amzn.to/1dG8IOC
Today we’re going to make a DIY action camera out of an old phone. An old phone with a smashed screen is almost worthless, but camera still works so we can use it for our action cam.
Most real action cams feature a wide angle lens to get more close up action in on the shot, so we’ll need to spend $7 on amazon for a stick on lens. This kit actually comes with a few of them, but we’ll only be using the fisheye.
You can use tape, or even a belt, but I used this two sided hook & loop fastener for 6 bucks.
First, glue the fisheye on to the center of the phone camera lens. Be careful not to get any glue on the glass. I’m using hot glue so that I can peel it off if I make a mistake. The trick is to glue it on while it’s really hot, or the lens will likely pop off later. You can use silicone glue for a better adhesion.
Next, we glue the strap to the phone, right on the end.
If you were able to get free shipping, this whole hack only cost us $14, versus $120 for an entry level GoPro hero. This works well, but I’m sure we can still make it better. Share any ideas you have in the comments on a handlebar mount, helmet mount, or ways we can make this design more effective.
Hook & Loop Strap: http://amzn.to/1dG8IOC
Today we’re going to make a DIY action camera out of an old phone. An old phone with a smashed screen is almost worthless, but camera still works so we can use it for our action cam.
Most real action cams feature a wide angle lens to get more close up action in on the shot, so we’ll need to spend $7 on amazon for a stick on lens. This kit actually comes with a few of them, but we’ll only be using the fisheye.
You can use tape, or even a belt, but I used this two sided hook & loop fastener for 6 bucks.
First, glue the fisheye on to the center of the phone camera lens. Be careful not to get any glue on the glass. I’m using hot glue so that I can peel it off if I make a mistake. The trick is to glue it on while it’s really hot, or the lens will likely pop off later. You can use silicone glue for a better adhesion.
Next, we glue the strap to the phone, right on the end.
If you were able to get free shipping, this whole hack only cost us $14, versus $120 for an entry level GoPro hero. This works well, but I’m sure we can still make it better. Share any ideas you have in the comments on a handlebar mount, helmet mount, or ways we can make this design more effective.
9 سال پیش
در تاریخ 1394/04/14 منتشر شده
است.
400,809
بـار بازدید شده