Making A Longboard Bracelet
12.7 هزار بار بازدید -
7 سال پیش
-
Making a Longboard Bracelet by
Making a Longboard Bracelet by Danial Rees from www.ZebranoWoodCraft.com. This simple woodworking project can be made with minimal supplies and hand tools.
To make my longboard bracelet I used a similar technique to my video on "How To Make A Bentwood Bangle" here: How to Make a Bent Wood Bangle Cuff
I started by cutting out an oval shaped former on my bandsaw that was approximately 60mm x 52mm. You can find bangle sizes with a simple Google search and this seemed to be a good fit for the recipient.
The woods I used were Walnut and Anigre veneer. I chose these woods as they were plyable enough without soaking or heating and I was able to make the bangle in one sitting. You could use any standard thickness wood veneer to make this type of bracelet but some species might need extra preparation.
The bangle itself was made with 5 strips of wood and I alternated the layers between the Walnut and the Anigre to give that longboard ply effect.
Overall I am happy with the project though I would ideally like to use a thinner drill bit for the holes next time.
If you enjoyed this type of DIY video then please give it a thumbs up and Subscribe to my channel! Thanks for watching!
www.ZebranoWoodCraft.com
To make my longboard bracelet I used a similar technique to my video on "How To Make A Bentwood Bangle" here: How to Make a Bent Wood Bangle Cuff
I started by cutting out an oval shaped former on my bandsaw that was approximately 60mm x 52mm. You can find bangle sizes with a simple Google search and this seemed to be a good fit for the recipient.
The woods I used were Walnut and Anigre veneer. I chose these woods as they were plyable enough without soaking or heating and I was able to make the bangle in one sitting. You could use any standard thickness wood veneer to make this type of bracelet but some species might need extra preparation.
The bangle itself was made with 5 strips of wood and I alternated the layers between the Walnut and the Anigre to give that longboard ply effect.
Overall I am happy with the project though I would ideally like to use a thinner drill bit for the holes next time.
If you enjoyed this type of DIY video then please give it a thumbs up and Subscribe to my channel! Thanks for watching!
www.ZebranoWoodCraft.com
7 سال پیش
در تاریخ 1396/07/05 منتشر شده
است.
12,732
بـار بازدید شده