Converting my horizontal metal cutting bandsaw to vertical
11.8 هزار بار بازدید -
9 ماه پیش
-
In this video I modify
In this video I modify my existing horizontal metal cutting bandsaw so that I can use it in a vertical configuration. In the vertical mode I can make use of the in feed table to make profiled and curved cuts in aluminium and steel plate.
Support the channel;
Patreon: joneseymakes
Buy project plans, 3D printable items and merch!
https://www.joneseymakes.com/
Check me out on instagram;
Instagram: joneseymakes
Timestamps
0:00 Introduction
0:32 Making curved cuts on the bandsaw
1:07 Freeing the swing arm
1:29 How to attach the in feed table?
1:45 Making the in feed table
1:58 Squaring up the plate
3:11 Machining the top
4:04 Counter bored bolt holes
4:39 Chamfering the edges
4:48 Cutting a slot in the steel plate
6:39 Fitting the in feed table to the saw
6:50 Test cut
7:15 Conclusion
Support the channel;
Patreon: joneseymakes
Buy project plans, 3D printable items and merch!
https://www.joneseymakes.com/
Check me out on instagram;
Instagram: joneseymakes
Timestamps
0:00 Introduction
0:32 Making curved cuts on the bandsaw
1:07 Freeing the swing arm
1:29 How to attach the in feed table?
1:45 Making the in feed table
1:58 Squaring up the plate
3:11 Machining the top
4:04 Counter bored bolt holes
4:39 Chamfering the edges
4:48 Cutting a slot in the steel plate
6:39 Fitting the in feed table to the saw
6:50 Test cut
7:15 Conclusion
9 ماه پیش
در تاریخ 1402/09/04 منتشر شده
است.
11,843
بـار بازدید شده