SNS 204: Thread Repair Inserts, Boring Mill, Large Gearbox Build, G&E Catalog
480.6 هزار بار بازدید -
7 سال پیش
-
I was given a gearbox
I was given a gearbox housing that required some thread repairs done on it. I use the key-locking thread inserts and how to install them.
I'll give you a look at the two gearbox shafts from the last episode installed in the box, and all of the other internals including a large new gear with a 20" bore.
By request I show the new G&E shaper catalog in a better close-up view, and a couple of viewer gifts that arrived for the shaper.
Want to support the efforts of this channel? Patreon: abom79
Abom79 swag available here: https://storefrontier.com/collections...
I'll give you a look at the two gearbox shafts from the last episode installed in the box, and all of the other internals including a large new gear with a 20" bore.
By request I show the new G&E shaper catalog in a better close-up view, and a couple of viewer gifts that arrived for the shaper.
Want to support the efforts of this channel? Patreon: abom79
Abom79 swag available here: https://storefrontier.com/collections...
7 سال پیش
در تاریخ 1396/11/28 منتشر شده
است.
480,695
بـار بازدید شده