Setting Z-Offset for a BLTouch (or another probe)
461 هزار بار بازدید -
4 سال پیش
-
Did you just install a
Did you just install a BLTouch (or other ABL) and now you’re printing in mid air? This video goes over how to find the proper z-offset value for your probe.
Edit: A lot of people ask how to “go below 0mm Z.” My firmware (Vanilla Marlin 2.x) is set in configuration.g to allow me to go 5mm below zero. However, you can also Send M211 S0 via terminal (octoprint or pronterface) to unlimit axes. When you are done, just send M211 S1 to re-enable axes limits.
Edit: A lot of people ask how to “go below 0mm Z.” My firmware (Vanilla Marlin 2.x) is set in configuration.g to allow me to go 5mm below zero. However, you can also Send M211 S0 via terminal (octoprint or pronterface) to unlimit axes. When you are done, just send M211 S1 to re-enable axes limits.
4 سال پیش
در تاریخ 1399/04/06 منتشر شده
است.
461,093
بـار بازدید شده