VeraPlus Home Automation Controller Setup

Setting up the VeraPlus and trying to copy the configuration data off the old VeraLite controller. My Vera Lite came with the older UI5 user interface software and did not have the same setup process. With UI7, you run the Setup Wizard and it walks you through most of the steps to set up the new controller. From a Vera user forum post, I found for transferring data from the old Vera Lite, if I did a "Copy Z-Wave network from a primary controller" on the new (i.e. secondary) Vera Plus and then a "Controller shift" on the old (i.e. primary) Vera Lite, that seemed to get the two controllers to sync up to some degree: forum.micasaverde.com/index.php/topic,28567.15.htm… If anyone has any experience with this upgrade path, post up in the comment section below or via PM or e-mail. It appears most of the line powered devices came over, a few with my names but most with the generic names. No scene or room information or any apps/settings were transferred. No battery power devices showed up. Be sure to rate, comment and share And as always, thanks for watching SOUNDTRACK: Louisiana Fairytale by Austin Rogers drfiddle.com/show_tune.php?id=94

• #science_technology
• #home_automation
• #vera
• #veralite
• #veraplus
• #vera_lite
• #vera_plus
• #micasaverde
• #mios
• #zwave
• #zwave_plus
• #zwave