Como PROBAR el SENSOR DEL ARBOL DE LEVAS con un MULTIMETRO ( SENSOR CMP )
43.1 هزار بار بازدید -
12 ماه پیش
-
I teach you how to
I teach you how to test the camshaft position sensor of any car with a multimeter also called cmp sensor to know if it is in good condition or it is already damaged and you have to change it.
The function of the camshaft sensor is to send a signal to the computer of the exact position of the intake camshaft and with that reading it adjusts the ignition timing and gasoline injection so that the engine starts well and runs correctly.
When the camshaft position sensor is already damaged, the following faults will occur in the vehicle: the engine does not start, loss of engine power, jerking when accelerating, excessive gasoline consumption, the engine accelerates on its own. , the engine suddenly turns off while driving, the transmission locks in a single gear and the yellow check light on the instrument panel comes on and when scanning the fault code p0340 appears.
And the solutions to camshaft position sensor failures are as follows: check that the cables and harness are not broken or burned, check that there is resistance measurement in the camshaft sensor with a multimeter, check that The battery is in good condition and perform maintenance on the starter motor and check its cables.
The function of the camshaft sensor is to send a signal to the computer of the exact position of the intake camshaft and with that reading it adjusts the ignition timing and gasoline injection so that the engine starts well and runs correctly.
When the camshaft position sensor is already damaged, the following faults will occur in the vehicle: the engine does not start, loss of engine power, jerking when accelerating, excessive gasoline consumption, the engine accelerates on its own. , the engine suddenly turns off while driving, the transmission locks in a single gear and the yellow check light on the instrument panel comes on and when scanning the fault code p0340 appears.
And the solutions to camshaft position sensor failures are as follows: check that the cables and harness are not broken or burned, check that there is resistance measurement in the camshaft sensor with a multimeter, check that The battery is in good condition and perform maintenance on the starter motor and check its cables.
12 ماه پیش
در تاریخ 1402/05/16 منتشر شده
است.
43,171
بـار بازدید شده