DIY PCB on a 3018 PRO CNC using Single Sided Copper Clad FR-4
54.4 هزار بار بازدید -
3 سال پیش
-
This is a video of
This is a video of my DIY milling of a single sided PCB (FR-4 copper clad) using a CNC-3018 PRO and laser etching the front fiberglass i.e. FR-4 face using a 7W blue laser to mark components and values.
The back copper plane and front fiberglass face were processed using slightly different toolchains.
Copper Toolchain
1. KiCad EDA: https://www.kicad.org
2. FlatCAM: http://flatcam.org
3. Candle: https://github.com/Denvi/Candle
Fiberglass Face
1. KiCad EDA: https://www.kicad.org
2. Inkscape: https://inkscape.org
3. LaserGRBL: https://lasergrbl.com
Note: The video was made over multiple milling attempts using different sized v-bits. The final PCB shown was made using a 30° 0.1mm V-bit whereas the milling footage is using a 30° 0.2mm V-bit.
Chapter Timestamps
00:00 Create Heightmap
00:45 Milling Process
01:27 PTH Drilling
02:01 NPTH Drilling
02:46 Board Cutout
03:19 Pre-assembly Inspection
04:17 Post-assembly Inspection
The back copper plane and front fiberglass face were processed using slightly different toolchains.
Copper Toolchain
1. KiCad EDA: https://www.kicad.org
2. FlatCAM: http://flatcam.org
3. Candle: https://github.com/Denvi/Candle
Fiberglass Face
1. KiCad EDA: https://www.kicad.org
2. Inkscape: https://inkscape.org
3. LaserGRBL: https://lasergrbl.com
Note: The video was made over multiple milling attempts using different sized v-bits. The final PCB shown was made using a 30° 0.1mm V-bit whereas the milling footage is using a 30° 0.2mm V-bit.
Chapter Timestamps
00:00 Create Heightmap
00:45 Milling Process
01:27 PTH Drilling
02:01 NPTH Drilling
02:46 Board Cutout
03:19 Pre-assembly Inspection
04:17 Post-assembly Inspection
3 سال پیش
در تاریخ 1400/05/22 منتشر شده
است.
54,452
بـار بازدید شده