Post & Beam vs. Post & Plate: Which is Best for Mass Timber?
24.9 هزار بار بازدید -
4 سال پیش
-
Mass timber panels including cross
Mass timber panels including cross laminated timber (CLT) have the ability to span in 2-directions, using structural properties obtained in both the major and minor panel axes. Doing so can result in a beamless system often referred to as Post and Plate (a framing configuration also used in flat plate concrete construction). Vertical columns support the floor and roof panels at discrete locations. On the other hand, mass timber horizontal panels can span one direction, supported on a series of beams and then columns. So which system is the best for mass timber? Check out this video for comparisons of each, and some project types where each of these systems could work well.
👇 SUBSCRIBE TO THE MASS TIMBER HOW TO'S YOUTUBE CHANNEL 👇
@masstimberhowtos
►Let's connect on LinkedIn: LinkedIn: ricky-mclain-pe-se-26116759
Ricky McLain is a structural engineer and mass timber specialist at WoodWorks. This video and this channel are based purely on Ricky's own observations, experiences and opinions and do not necessarily reflect the opinion nor beliefs of WoodWorks.
To send mass timber video clips you have for use in these future videos, send a DM through LinkedIn (link above).
#masstimber #structuralengineering #architecture
👇 SUBSCRIBE TO THE MASS TIMBER HOW TO'S YOUTUBE CHANNEL 👇
@masstimberhowtos
►Let's connect on LinkedIn: LinkedIn: ricky-mclain-pe-se-26116759
Ricky McLain is a structural engineer and mass timber specialist at WoodWorks. This video and this channel are based purely on Ricky's own observations, experiences and opinions and do not necessarily reflect the opinion nor beliefs of WoodWorks.
To send mass timber video clips you have for use in these future videos, send a DM through LinkedIn (link above).
#masstimber #structuralengineering #architecture
4 سال پیش
در تاریخ 1399/10/23 منتشر شده
است.
24,987
بـار بازدید شده