How to Make an Internal 90 Bend in Electrical Trunking using an Angle Grinder
1.7 هزار بار بازدید -
5 ماه پیش
-
The how to guide to
The how to guide to manufacture an internal 90 degree trunking bend, step by step clearly showing how to make to a set measurement. This method uses an angle grinder although an hacksaw would be also as good (the method I normally use to demonstrate to students in a class safer). Looks as good or better than a bought one. Lid not shown but out of all lid to make, this again is the easiest.
5 ماه پیش
در تاریخ 1402/11/14 منتشر شده
است.
1,798
بـار بازدید شده