Arduino Custom Wireless Keyboard! | #P4
33.7 هزار بار بازدید -
3 سال پیش
-
In this video I show
In this video I show you how to make any size custom wireless keyboard using any Arduino micro controller board. It's a perfect Arduino project! Here, the Attiny84 is used with the nRF24L01 radio module. You can also 3D print a case for it, or use the one I created. In this project, first we start by creating a prototype keyboard using a breadboard, then show you an idea of how you can combine the Arduino micro controllers with all the wiring and buttons to make a complete custom wireless Arduino based keyboard.
Comment below on what project you want me to do next! It could really be anything!
I made sure the keyboard draws the least amount of current by using an Attiny micro-controller and the nRF24L01 module. At the end, the total current consumption was 1.284 mA, which meant the keyboard can last for 16 days using a single coin battery, the CR2450. However, this is assuming the keyboard is on 24/7, but in practise, the keyboard, like any other wireless device, will be turned off when not in use, for example before going to bed. So a more realistic value will be that the wireless Arduino keyboard will last approximately 30 days.
This arduino custom wireless keyboard was setup using a transmitter and a receiver. With the receiver micro-controller always connected to the computer, so it doesn't really matter which is used, but I have used the Pro Micro. For the transmitter, we need a micro-controller that has low current consumption, so the Attiny micro controllers work great for this kind of project. I have chosen the Attiny84 for the breadboard prototype version, and the Attiny88 for the final version for the 3D printed case.
Components required for the project:
- Attiny84/85/88 (or any low current consuming MC).
- nRF24L01, two of them.
- Pro micro, or any micro-controller with HID support to act like the receiver.
- Some buttons, any, I have used linear Cherry MX switches.
- CR2450 coin battery, and its battery holder.
- A 3.3v voltage regulator, I have used the MCP1700, with 1000µF (could be 100µF) electrolytic capacitor, and a 104Z ceramic capacitor, soldered directly on to the MCP1700 voltage regulator, between the GND and VCC pins.
To design all the 3D models I used Fusion 360, and printed them using the Creality CR6 SE 3D printer.
Remember to Subscribe! :) I have over 50 amazing projects planned!
Link to the code and 3D models:
github.com/ProjectsWithRed/wireless_keyboard
Instagram, Twitter, Facebook:
@projectswithred
0:00 Intro
0:27 Components
02:32 Wiring
02:46 Arduino
04:33 Demo
05:53 3D printing
06:59 Outro
#arduino #arduinoproject #keyboard #wireless #3dprinting #wirelesskeyboard
3 سال پیش
در تاریخ 1400/01/15 منتشر شده
است.
33,757
بـار بازدید شده