How To Make A PVC Train Horn (For Real)

Lonnie's Garage (Puppetkicker)
Lonnie's Garage (Puppetkicker)
182.6 هزار بار بازدید - 11 سال پیش - The Website That I Got
The Website That I Got This From Is (www.jeepforum.com/forum/f8/pvc-train-horn-build-13…. I Did Not Steal The Plans As You Can See If You Go To The Site It Will Tell You How To Make It. I Just Made A Video Showing You How. ATTENTION BUILD AT YOUR OWN RISK!!!! I TAKE NO FAULT OR RESPONSABILITY FOR ANY DAMAGES TO YOU OR YOUR PROPERTY! IF YOU CHOSE TO USE SOME OF MY IDEA'S IT IS AT YOUR OWN RISK... PLEASE BE SAFE, AND REMEMBER MODIFYING ANYTHING COMES WITH GREAT RISK!!! PROCEED AT YOUR OWN RISK!!! Also dont forget to Like and Share... You can find me on Facebook. My Youtube: youtube.com/user/PuppetKicker My Facebook: www.facebook.com/lonnie.puppetkicker Items You Will Need Are (For One Train Horn) 1 4in To 2in Cup-link 1 2in To 1in Adapter 1 Stick Of 4in PVC Pipe 1 Stick Of 1in PVC Pipe 1 Transmission Funnel 1 Butter Bowl Lid 1 Air Valve And Some PVC Glue Instructions are 1st Cut 1 1/2in and 1 1in Piece Of 4in PVC. 2nd Take Your Butter Bowl Lid And Put Your 1in By 4in On It And Cut Around It. 3rd Drill A Hole Big Enough For Your Air Valve In The 4in To 2in Cup-link And Put It In. 4th Glue Your 1/2in By 4in Into The 4in To 2in Cup-link Making Sure You Have It Pushed As Far Down Inside Of It As It Can Go. 5th Put Your Cut Out Butter Bowl Lid On Top Of The 1/2in By 4in That You Just Glued Inside Of The 4in To 2in Cup-link. 6th Put Your 1in by 4in Piece On Top Of The Cut Out Butter Bowl Lid Making Sure Its Tight Against The Lid. 7th Mark And Drill 3 Hols To Hold The 1in By 4in Tight Against The Butter Bowl Lid And Put Your Bolts In And Tighten Them. 8th Carve Out The Lip Inside Of The 2in To 1in Adapter So That The 1in PVC Pipe Will Slide All The Way Through Without Stopping And Then Glue The 2in To 1in In The 4in To 2in Cup-link. 9th Put Your 1in PVC Pipe Into The 2in To 1in Adapter And Push In Untell It Touches The Butter Bowl Lid But It Needs To Be Against It With A Little Pressure And Glue The 1in PVC In Place. 10th Cut The Funnel To Slid Tightly On The 1in PVC Pipe. 11th Let All Dry And Have Some Fun. Build Time Took Me About 1hr To Cut And Make Everything. Many Many Thanks To The Man On The Jeep Forums That I Found. Your Instructions Were Great And Easy. I Hope This Helps Everyone Out Please Rate Comment And Sub. P.S. Sorry For The Bad Spelling And Rough Directions
11 سال پیش در تاریخ 1392/07/24 منتشر شده است.
182,666 بـار بازدید شده
... بیشتر