Tympanic bearing edge machining.
1.6 هزار بار بازدید -
4 سال پیش
-
A brief video showing the
A brief video showing the basic machining steps. Video recorded 2015. This video offered purely to assist those asking how this is done. We are no longer crafting Guru Drums.
A standard radius cutter is used. Cutter size should be selected allowing for sufficient shell / reinforcement ring thickness to accommodate the finished bearing edge form.
Of note - we only ever used this edge form on the resonant side of one drum series. It was used in combination with a very rounded batter edge to give a lot of batter head control, but a wide open resonant side. The result was a very balanced acoustic delivery, but very well controlled batter side for close micing.
A standard radius cutter is used. Cutter size should be selected allowing for sufficient shell / reinforcement ring thickness to accommodate the finished bearing edge form.
Of note - we only ever used this edge form on the resonant side of one drum series. It was used in combination with a very rounded batter edge to give a lot of batter head control, but a wide open resonant side. The result was a very balanced acoustic delivery, but very well controlled batter side for close micing.
4 سال پیش
در تاریخ 1399/05/14 منتشر شده
است.
1,698
بـار بازدید شده