كل شيء عن السيليكون الحراري (عظم) اقوى لاصق لاي مادة !!! والفرق بين الاصلي والتقليد
154.9 هزار بار بازدید -
5 سال پیش
-
The strongest adhesive for plastic.
The strongest adhesive for plastic. A strong adhesive for leather, glass, metal, and wood against water, heat, and pressure to make gaskets, to make molds ... and mooore a lot. Silicone sealant skins over within 15 minutes, commpletely cures after 24 hours of application, creates an extremely strong adhesive rubber layer, (like gum - with the difference in strength of cource), which is leak-proof, resistant to pressure, heat, permeability and aging. So it is considered an adhesive that can be used on almost any solid surface !!! An adhesive that is resistant to most fluids, liquids and gases and chemicals, thus it's considered a very good water proof sealant and an excellent material to #stopleak (See below *** How to Remove Silicon #sealant ***)
** Important note **
How to remove silicone from the hand: (Be careful if you use your hand to weld by silicone)
Initially, you should use only one or two fingers to distribute the silicone in the desired location for welding (since it is very sticky to skin / leather in general)
After finishing, do not wash your hand at all, so that the silicone will not spread over the entire hand, as it is difficult to remove it.
- Just wipe your finger with a cloth to remove as much silicone as possible
- You can rub your finger in sand or stone to remove the rest of the silicon
After that, wash your hand thoroughly with soap and water (silicone scrub becomes easier over time when it dries up)
*** If you feel that the silicone residue is still stuck in your hand, rinse your hand ((with vinegar)) well ((for two minutes only)) as the vinegar is safe, effective and very fast in removing any #adhesive (vinegar may cause stinging in places of wounds, but it is a Natural substance and always safe to use) - Then just rinse with water, enough to remove vinegar from your hand. This chemically makes it easier to remove silicone residues by rubbing
** Important note **
How to remove silicone from the hand: (Be careful if you use your hand to weld by silicone)
Initially, you should use only one or two fingers to distribute the silicone in the desired location for welding (since it is very sticky to skin / leather in general)
After finishing, do not wash your hand at all, so that the silicone will not spread over the entire hand, as it is difficult to remove it.
- Just wipe your finger with a cloth to remove as much silicone as possible
- You can rub your finger in sand or stone to remove the rest of the silicon
After that, wash your hand thoroughly with soap and water (silicone scrub becomes easier over time when it dries up)
*** If you feel that the silicone residue is still stuck in your hand, rinse your hand ((with vinegar)) well ((for two minutes only)) as the vinegar is safe, effective and very fast in removing any #adhesive (vinegar may cause stinging in places of wounds, but it is a Natural substance and always safe to use) - Then just rinse with water, enough to remove vinegar from your hand. This chemically makes it easier to remove silicone residues by rubbing
5 سال پیش
در تاریخ 1398/01/17 منتشر شده
است.
154,917
بـار بازدید شده