Install 1/2 channel relay switch to Epson Projector to behave LED like the original lamp(part 3)

Actually i need to turn ON and OFF the led because having the light ON all the time when the projector was plugged in was awkward. So, i got 2 channel relay switch for this project. This small beast could handle 10A at 250V. When it receives the signal from the projector motherboard, then it sends signal through the relay switch to the motherboard that lamp is present as well as current through the relay switching the AC voltage into the LED driver thus turning the LED ON. This way LED would behave exactly like the original lamp and it allow the projector to turn ON and OFF the LED itself.

• #science_technology
• #1_channel_relay_switch
• #2_channel_relay_switch
• #install_relay_in_projector
• #relay_allow_the_projector_to_turn_on_and_off_the_led_itself
• #how_to_install_relay_switch_in_projector
• #how_to_get_signal_from_projector_motherboard_to_switch_led_on
• #led
• #how_led_would_behave_exactly_like_the_original_lamp
• #automatic_off_the_projector_led
• #power_switch_led_off_and_on