1999 Toyota 4Runner Alternator Replacement and Wire Repair | How to tell if your Alternator is Bad

4WheelKid
4WheelKid
25.3 هزار بار بازدید - 3 سال پیش - I was in the process
I was in the process of replacing my timing belt when I noticed the 3 pin plug for the alternator had a corroded/burned pin. I had a Denso remanufactured alternator I planned to put in during the timing belt job since I was having electrical issues. I ordered a new connector pigtail and I show you how to install it properly. I wasn't originally planning on showing how to replace the alternator but since the new remanufactured one was bad out of the box, I show how to swap it out. Hope this was helpful and thanks for watching!

Disclaimer: work on and modify your vehicle at your own risk. You are solely responsible for your actions. Always use proper safety equipment for the job.

Timeline:
Intro: 0:00
Burned/corroded plug repair: 0:27
Bad remanufactured alternator diagnosis: 5:46
Alternator replacement: 8:44
finally fixed: 1646

find the connector repair supplies here:
3rd gen 4runner connector harness here: https://amzn.to/3BrY5Kt (paid link)
waterproof crimps: https://amzn.to/3EAcPsq (paid link)
My favorite wire stripper: https://amzn.to/3mxV1Im (paid link)
My favorite wire crimper: https://amzn.to/3CyY60q (paid link)
low temp heat gun: https://amzn.to/3w3rxVN (paid link)
(I may get commissions for purchases made through links with "paid link" next to them, buying from one of these links will help me support the channel at no extra cost to you.)
3 سال پیش در تاریخ 1400/08/09 منتشر شده است.
25,326 بـار بازدید شده
... بیشتر